Table 1-37 Operating Parameters That Can Be Set For Each Operation - Hitachi GR2000 Series Configuration Commands
Hitachi gigabit router configuration guide
Hide thumbs
Also See for GR2000 Series:
- Installation manual (18 pages) ,
- Installation manual (410 pages)
Table of Contents
Advertisement
Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
Table 1-37 Operating Parameters that Can Be Set for Each Operation
Operation Parameter
Existence of operating parameter
-action
Contract band monitoring
{ -upc <kbps> [-upc_burst
<Size>]| -min_rate <kbps> [-
min_rate_burst <Byte>]| -
max_rate <kbps> [-
max_rate_burst <Byte>]| -
max_rate <kbps> [-
max_rate_burst <Byte>] -
min_rate <kbps> [-
min_rate_burst <Byte>]}
Output priority -priority <No.>
Queuing priority
-discard<No.>
User priority rewrite
-replace_user_priority <No.>
Group number
-group<No.>
DSCP rewrite
-replace_dscp <DSCP_Value>
Priority designation by input IP packet
DSCP
-dscp_map
Abortion at contract band breach.
-penalty_drop
Queuing priority at contract band
breach.
-penalty_discard <No.>
DSCP rewriting at contract band breach.
-penalty_dscp <DSCP_Value>
EXP rewrite (mpls packet only)
-replace_exp <Value>
Output VC and DLCI designation
-index <Value>
:
Indispensable
x:
Can be set, and default. No mark: Setting is impossible.
*1:
This is the operating parameter of contract band monitoring. These conditions cannot be set when
"-min_rate<kbps>[-min_rate_burst<Byte>]" is specified. To guarantee the minimum band, this parameter can only
change the queuing priority of a packet that violates the contract band.
*2:
This is the operating parameter of contract band monitoring. These conditions cannot be set when only
"-max_rate<kbps> [-max_rate_burst<Byte>]" is specified. To limit the maximum band, this parameter can only discard
a packet that violates the contract band.
*3:
This is the operating parameter of contract band monitoring. Omit these conditions when
"-max_rate<kbps>[-max_rate_burst<Byte>]" is specified.
*4:
This is the operating parameter of contract band monitoring. The operation of a packet that violates the contract
band of "-min_rate<kbps>" is specified when "-max_rate<kbps>[-max_rate_burst<Byte>]
-min_rate<kbps>[min_rate_burst<Byte>]" is specified.
*5:
No setting is possible on the VLAN line.
*6:
Only VLAN lines can be set. In addition, output priority determination and DSCP rewrite cannot be set
simultaneously.
1-64
2
3
5
1
4
(*1)
(*2)
(*1)
x
x
x
x
x
x
x(*3
(*3)
(*4)
x
x
x
x
x
Flow Control
6
8
9
7
10
(*2)
(*1)
(*2)
x
x
x(*3
)
(*4)
(*4)
x
x
x
x
x
13
11
12
(*6)
x
x
x
x
x
x
x
x
x
GR2K-GA-0014
Ver. 07-02
Advertisement
Table of Contents
