Table of Contents
Advertisement
8
en | Installation
2.3
Attach Pendant Arm to Junction Box
The bottom hinge pin of the Camera Arm is provided with a Hinge Pin Stop to hold the hinge
open while attaching the arm to the junction box.
1.
2.
NOTICE!
Both Hinge Pins must be fully compressed to open (unlock) the hinges of the Camera Arm and
before proceeding to the next step.
3.
4.
WARNING!
Serious injury or death can occur if the hinge pins of the Camera Arm are not fully engaged
(locked) to the junction box. Exercise caution before releasing the Camera Arm.
F.01U.166.250 | 1.0 | 2011.04
Compress the bottom hinge pin by pushing the pin lever downward and rotating it
behind the Hinge Pin Stop.
Figure 2.2 Camera Box Hinge Alignment
Open the top hinge by pushing its pin lever up and holding it.
While continuing to hold the top hinge pin, open and align the top and bottom hinges of
the Camera Arm to their mating points on the junction box. See Figure 2.2, above, for an
illustration.
Once you have aligned the hinges, release the top hinge pin to engage its mating hinge on
the junction box. Then release the bottom hinge pin from the Hinge Pin Stop to lock the
Camera Arm to the junction box.
Quick Install Guide
NEI-30 | VEI-30 Dinion Infrared Imager
Bosch Security Systems, Inc.
Advertisement
Table of Contents
