6
en | Installation
2
Installation
This chapter details how to mount the VEI-30 / NEI-30 to a wall. Any variations to the
installation procedures are noted.
2.1
Mount the Junction Box
Before mounting the junction box, decide if you should wire the box through the holes in the
bottom or back of the box. If wiring the box through the back, move the two (2) seal plugs to
the bottom through-holes before mounting. This installation must be made by a qualified
service person and must conform to all local codes.
NOTICE!
Use 3/4 in. (20 mm) NPS fittings for the holes on the bottom and back of the box. Use 1/2 in.
(15 mm) NPS fittings for the side holes.
Figure 2.1 Junction Box Wall Mount
WARNING!
The camera has been evaluated for wall mounting using the following hardware secured into a
2 x 4 stud under 1/2 in. drywall:
–
–
F.01U.166.250 | 1.0 | 2011.04
Four (4) Lag bolts, 1/4-9 x 2 (M7-0.35 x 50) with 1/2 in. head
Four (4) 1/2 in. (12 mm) flat washers
Quick Install Guide
NEI-30 | VEI-30 Dinion Infrared Imager
Bosch Security Systems, Inc.