iNSTALLATiON
AND SERVICE
MUST BE PERFORMED
BY A QUALiFiED
iNSTALLER,
iMPORTANT:
SAVE FOR LOCAL ELECTRICAL
iNSPECTOR'S
;E. READ AND SAVE THESE iNSTRUCTiONS
FOR FUTURE REFERENCE.
FORYOUR
SAFETY:
Do not store or use gasoline
or other
United States
flammable
vapors
and liquids in the vicinity
of this or any other appliance.
1. Clearances
and Dimensions
a. Provide adequate clearances between the range and adjacent combustible surfaces.
b. Location--Check
location where the range will be installed. Check for proper electrical supply and the stability of floor.
c. Dimensions that are shown must be used. Given dimensions
provide minimum clearance.
Contact surface must
be solid and level.
FRONT
CABINET INSTALLATION
SIDE
VIE
VIEW
Minimumto
1"
wall on either
side of range
above 36" height.
_
30"
30
_
Minimum*
t
Minimumto
|
18"
cabinets on
/
either side
_.
of range.
1_13"4_
Maximumdepth
for cabinets
_"I
above !ange !op_ _1
i_i
i
_301/8"_1
0"clearance bel0wc00king topandat rearofrange.
FRONT
VIEW
T
49"
Maximum
46"
Door open
29-7/8"__4"
\
4
30" minimum clearance between the top of the cooking surface
and the bottom of an unprotected wood or metal cabinet; or 24 "
minimum when bottom of wood or metal cabinet is protected by not
less than 1A"flame retardant millboard covered with not less than
no. 28 MSG sheet steel, 0.015" stainless steel, 0.024" aluminum
or 0.020" copper. The minimum clearance is O"for the rear of the
range. Follow all dimension requirements provided above to prevent
property damage, potential fire hazard, and incorrect countertop
and cabinet cuts.
Avoid locating
cabinet storage space above the surface units
to eliminate
the possibility of cabinets
catching
on fire, or
personal burns from reaching
for the cabinets
over the heated
units, if cabinet storage is to be provided, risk can be reduced by
installing a range hood that projects horizontally
a minimum
of
5" beyond the bottom of the cabinets.
Important
Notes to the Installer
1.
Read all instructions contained in these installation instructions
before installing the appliance.
2.
Remove all packing material before connecting the electrical
supply to the appliance.
3.
Observe all governing codes and ordinances.
4.
Be sure to leave these instructions with the consumer.
Important
Note to the Consumer
Keep these instructions with your Use and Care Guide for future reference.
Printed in Canada
BACK
VIEW
locationare maximum.
Cubed area shows
Terminal "
where the electrical
Block
_
outlet must be
Location
_i
installed for the
_L,_-_,_
range to be flush to
9' _. _
,
the wall.
318201734 (1211) Rev. B