Before Calling Service Technician; General Operation - Toshiba e-studio182 Operator's Manual
Multifunctional digital systems copying functions
Hide thumbs
Also See for e-studio182:
- Service manual (258 pages) ,
- User manual (52 pages) ,
- Quick start manual (44 pages)
Table of Contents
Advertisement
Before Calling Service Technician
When you encounter trouble using this equipment, check the items listed below.
General operation
Phenomenon
The equipment does not
operate at all.
The button does not respond
to my operation.
The LCD screen is too light/
dark.
A message is displayed on
the LCD screen.
"Enter DEPARTMENT
CODE" appears on the LCD
screen.
"Saving energy" appears on
the LCD screen.
"Sleep mode" appears on the
display.
The LCD screen is dim.
Scanning stops before it is
finished. ("Count over"
appears on the LCD screen.)
Scanning stops before it is
finished. ("Memory is full"
appears on the LCD screen.)
Copying stops before it is fin-
ished. ("Clear paper output
tray: PRESS START KEY."
appears on the display.)
Usual cause
The power of the equipment
is not turned ON.
The power cable is not
plugged in securely.
The weekly timer functions
and the equipment is in the
sleep mode.
It has been a short time
since the power was turned
ON.
The contrast of the LCD
screen is not adjusted prop-
erly.
The equipment has detected
an error status.
When the use of the equip-
ment is managed under
department management,
and the department code
has not been entered.
The equipment is in the low
power mode.
The equipment is in the
sleep mode.
The equipment is in the
super sleep mode.
The number of pages
scanned has exceeded the
maximum value.
The built-in memory of the
equipment has become full.
Approx. 250 sheets of paper
have continuously exited and
the equipment stops copy-
ing to prevent the copied
paper from overflowing from
the tray.
Before Calling Service Technician
Countermeasure
Turn ON the power of the equipment.
Plug in the power cable securely.
Press any of the [ENERGY SAVER] but-
ton, the [START] button and the function
switching buttons on the control panel.
Wait for the completion of warm-up and
then try again.
Adjust it with the contrast adjustment vol-
ume.
P.30 "Control panel"
See the meaning of the message refer-
ring to the listing below.
P.178 "When This Message Appears"
Enter your department code.
P.34 "Preparation 1 - Turning Power
ON"
P.141 "Department Code"
The equipment enters into the low power
mode after a specified time has passed
since its last use. Copying is enabled.
The equipment enters into the sleep
mode after a specified time has passed
since its last use. For how to cancel this
mode, see the following page.
P.35 "Saving energy when not in use -
Energy saving mode -"
The equipment enters into the super
sleep mode after a specified time has
passed since its last use. For how to can-
cel this mode, see the following page.
P.35 "Saving energy when not in use -
Energy saving mode -"
To copy the data scanned so far, select
"Print". To delete them, select "Cancel
job".
(If "Print" is grayed out, only data deletion
is possible.)
To copy the data scanned so far, select
"Print". To delete them, select "Cancel
job".
(If "Print" is grayed out, only data deletion
is possible.)
Remove the paper from the receiving tray,
and then press the [START] button. Copy-
ing resumes.
Press the [CLEAR/STOP] button to end
the copy job. "Memory clear?" appears on
the LCD screen. Select "YES", and then
press the [START] or [ENTER] button.
199
- Quick Links:
- List Print Format
Hide quick links:
Advertisement
Table of Contents
