Before Calling Service Technician; General Operation - Toshiba e-STUDIO203 Operator's Manual
Toshiba multifunctional digital system operator's manual
Hide thumbs
Also See for e-STUDIO203:
- Service handbook (222 pages) ,
- Service manual (236 pages) ,
- Operator's manual (162 pages)
Table of Contents
Advertisement
Before Calling Service Technician
When you encounter trouble using this equipment, check the items listed below.
General operation
Phenomenon
The equipment does not
operate at all.
The equipment does not
operate even when you press
any of the buttons.
Scanning stops in the middle.
(The [START] lamp is lit and
the [FUNCTION CLEAR]
lamp is blinking.)
Copying stops in the middle.
(The [START] lamp and the
middle paper jam position
lamp (
) are lit and the
[FUNCTION CLEAR] lamp is
blinking.)
Printing stops in the middle.
(The [START] lamp and the
middle paper jam position
lamp (
) are lit and the "Out
of paper" error dialog box is
displayed in the TOSHIBA
Viewer.)
"ALP" appears on the LED
display.
"SLP" appears on the LED
display.
Even when the equipment is
connected with a PC by a
USB cable, the equipment is
not recognized.
Usual cause
The power cable is not
plugged in securely.
One or more of the message
lamps is lit or blinking.
The equipment is in the
energy saving mode.
The access code needs to
be keyed in (when the equip-
ment is managed under the
access code function).
It has been a short time
since the power was turned
ON.
The built-in memory of the
equipment has become full.
Approx. 250 sheets of paper
have continuously exited and
the equipment stops copy-
ing to prevent the copied
paper from overflowing from
the tray.
Approx. 250 sheets of paper
have continuously exited and
the equipment stops printing
to prevent printed paper from
overflowing from the tray.
The equipment is in the low
power mode.
The equipment is in the
sleep mode.
This cable is not certified
according to the USB2.0 Hi-
Speed.
The equipment is connected
with a PC via a USB hub.
Before Calling Service Technician
Countermeasure
Plug in the power cable securely.
Check which lamp is lit or blinking and
take any countermeasure accordingly.
P.78 "When Message Lamp is Lit/
Blinking"
Press the [ENERGY SAVER] button to
cancel this mode.
P.30 "Saving energy when not in use -
Energy saving mode -"
Key in the 3-digit access code.
(For the details of the access code set-
ting, ask your service technician.)
Wait for the completion of warm-up and
then try again.
Press the [START] button to copy the data
scanned so far. Press the [FUNCTION
CLEAR] button to delete the data
scanned so far.
Remove the paper from the receiving tray,
and then press the [START] button. Copy-
ing resumes. Press the [FUNCTION
CLEAR] button to end the copy job.
Remove the paper from the receiving tray,
press the [START] button, and then click
the [OK] button in the "Out of paper" error
dialog box in the TOSHIBA Viewer. Print-
ing resumes.
The equipment automatically enters into
this mode when a specified period of time
has passed since its last use. Copying is
enabled.
The equipment automatically enters into
this mode when a specified period of time
has passed since its last use. Warm-up
starts either when print data are received
or when any button on the control panel is
pressed. Copying is enabled when the
warm-up has finished.
Use a USB2.0 Hi-Speed certified cable.
When the equipment is connected with a
PC via a USB hub, the equipment may
not be recognized. Connect it with a PC
directly by a USB cable.
95
Hide quick links:
Advertisement
Table of Contents
