Toshiba e-STUDIO453 Service Manual page 63
Hide thumbs
Also See for e-STUDIO453:
- Service handbook (764 pages) ,
- Operator's manual (362 pages) ,
- Printing manual (356 pages)
Table of Contents
Advertisement
(5) Take off the lower drawer of the equipment
and PFP upper drawer.
(6) Remove 4 screws and take off 2 fixing
brackets on the front side.
(7) Lift up the equipment and take off the PFP.
[C]
KD-1012 (Large Capacity Feeder (LCF))
(1) Turn OFF the power and unplug the power
cable.
(2) Take off the rear cover of the equipment.
(
Chapter 2.5.1 [C])
Note:
Disconnect the connectors of the RADF first
when the RADF is installed.
(3) Remove 1 screw and the ground wire, and
then disconnect 2 connectors (3 if the op-
tional damp heater is installed).
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Fig. 2-609
Fig. 2-610
Fig. 2-611
Fig. 2-612
2 - 43
e-STUDIO350/352/353/450/452/453
05/11
Connector of optional
damp heater
OUTLINE OF THE MACHINE
2
Advertisement
Table of Contents
