Table of Contents
Advertisement
Chapter 9 Connectivity Management
9.1 Connectivity Status
•
Port Mode
The mode of the target port is displayed.
-
-
•
Connection
The connection type of the target port is displayed.
-
-
•
Loop ID
If the connection type of the target port is "FC-AL", the Loop ID is displayed.
"Loop ID" is an identification number of a node in a loop.
When the connection type of the target port is "Fabric", a "-" (hyphen) is displayed.
•
Transfer Rate
The transfer speed of the target port is displayed.
-
-
-
-
•
FC Frame Size
The frame size of the target port is displayed.
"FC Frame Size" specifies the length of the communication information.
-
-
-
•
Reset Scope
The reset scope of the target port is displayed.
Reset scope is the range where the command reset request from the server is performed,
when the target port is connected to multiple servers.
A "-" (hyphen) is displayed when the port mode is "RA".
-
-
•
Release Reservation if Chip is Reset
When you enable the function to release the volume's reserved status when the target port
(chip) is reset, "Enable" is displayed. If you disable the function, "Disable" is displayed.
A "-" (hyphen) is displayed when the port mode is "RA".
CA
RA
Fabric
A connection type that enables simultaneous communication among multiple nodes
through a fibre channel switch.
FC-AL
Multiple nodes are connected in a loop topology.
Auto-negotiation
2 Gbit/s
4 Gbit/s
8 Gbit/s
2048 bytes
1024 bytes
512 bytes
I_T_L (I: Initiator, T: Target, L: LUN)
Reset (cancel) the command request from the server that sent the command reset
request.
T_L (T: Target, L: LUN)
Reset (cancels) the command request from all of the servers that are connected to the
port.
ETERNUS Web GUI User's Guide
Copyright 2011 FUJITSU LIMITED
272
P2X0-1090-02ENZ0
Advertisement
Table of Contents
