Summary of Contents for Craftsman 247.370320 Owner's g
Page 1
,4U6 2 0 J997 Owner's Manual CRAFTSMAN° 21" Mulching/Side-Discharge PUSH LAWN MOWER Model No. 247.370320 CAUTION: Before using this product, read this manual and follow all Safety Rules and Operating Instructions. Sears, Roebuck and Co., Hoffman Estates, IL 60179, U.S.A.
Page 2
Lawn Mower For two years from the date of purchase, when this Craftsman lawn mower is maintained, lubricated, and tuned up according to the instructions in the owner's manual, Sears will repair, free of charge, any defects in material or workmanship.
Page 3
This symbol points out important safety instructions which, if not followed, could endanger the per- sonal safety and/or property of yourself and others. Read and follow all instructionsin this manual before attempting to operate your lawn.mower. Failureto comply with these instructionsmay resultin personal injury.When you see this symbol--heed its warning.
Page 4
walking. If you must back the mower away from a a slopeor hilly area. If the slope isgreater than 15 degrees waltor obstruction first look down and behind, and as shownon the slopegauge (page 6), do notoperatethis then follow these steps: uniton thatarea or seriousinjurycould result.
Page 5
Keep all nuts, bolts, and screwstight to be sure Use only an approved gasoline container. Never remove gas cap or add fuel while the the equipment is in safe workingcondition. engine is running. Allow engine to cool at least Never tamper with safety devices. Check their two minutesbefore refueling.
Page 6
SIGHT AND HOLD THIS LEVEL WITH A VERTICAL TREE POWER POLE Ii.q _" _ _. _. A CORNER OF A BUILDING OR A FENCE POST _" , -._: - __Okoo _ _li_ il ' °II:: 411i,m,,/ill, u.I U.I a. _ Do not mow on inclines with a slope in excess of 15 degrees (a rise of approximately 2-112 feet every 10 feet).
Page 7
REMOVING UNIT FROM CARTON mower and/or front or behind the mower is observed from the operating position. • Remove staples, break glue on top flaps, or cut LOOSE PARTS tape at carton end and peel along top flap to open carton. a.
Page 8
Note: Make sure to route the cables inside the lower mulching cover to the deck. See Figure 5A. handle. Also do not crimp the cables while rifting the Keep the cover in a safe place for future use. Save the wing nuts. handle up, Ptace the side discharge chute on the deck in For shipping purposes, the hairpin clip is placed in the...
Page 9
This control mechanism is a safety device. Never attempt to bypass freely on level ground. its operations. MEETS CPSC BLADE SAFETY STANDARDS Craftsman Walk-Behind Lawn Mowers conform to the safety standards of the American National Standards Institute and the U.S. Consumer Product Safety Commission.
Page 10
STOPPING ENGINE NOTE: Although multi-viscosity oils (5W30, 10W30, etc.) improve starting in cold weather, these multiviscosity oils will result in increased oil Release blade control handle to stop the engine and the blade. consumption when used above 32°F. Check the oil Disconnect spark plug wire and move away level more frequently to avoid possible engine from spark plug to prevent accidental starting.
Page 11
stroke. K eepingafirmgriponthestarter USING YOUR LAWN MOWER handle, l ettheropereturn tothestarter s lowly. • Aftertheengine starts, m ove throttle control t o Your mower is designed to operate as a mulching or a desired engine speed. side discharge unit. Note: ff engine fails to start after three pulls, repeat •...
Page 12
GENERAL RECOMMENDATIONS Disconnect spark plug wire. Drain the gasoline from the lawn mower, or Always observe safety rules when performing place a piece of plastic under the gas cap. any maintenance. Tip the mower so that it rests on the housing. The warranty on this lawn mower does not cover Keep the side with the air cleaner facing up.
Page 13
Engine Oil Wrap in a clean cloth and squeeze (do not twist) until completely dry, or allow to air dry. Only use high quality detergent oil rated with Saturate with engine oil and squeeze (don't API service classification SF, SG or SH. Select twist) to distribute oil and remove excess oil.
Page 14
assembly. Use a grease gun to lubricate the washing with a commercial solvent. casters every 25 operating hours or so. Feeler gap .030" Blade Control Handle • Lubricate the pivot points on the blade control handle and the brake cable at least once a season with light oil.
Page 15
BLADE CARE recommended torque for the bolt which is 450- 600 in.-Ibs. Periodically inspect the blade adapter for cracks, IMPORTANT: The bolt, used to secure the blade to especially if you strike a foreign object. Replace when the engine, is specially heat-treated. Do not necessary.
Page 16
ADJUSTING CUTTING HEIGHT takeyour lawn mower to your nearest SEARS service center. • Engine performance may be affected in IMPORTANT: All wheels must be placed in the same altitudes above 4000 feet. To improve engine relative position. Raise the mower wheels for low cut performance, install a high altitude adjustment and /ower the wheels for high cut.
Page 17
Prepare yourlawnmower f orstorage attheendofthe Acidic gas can damage the fuel system of an engine season orif the unit will not be used for 30 days or while in storage. more. Store the mower in a clean, dry area. Drain fuel system & carburetor MOWER container outdoors away from open flame.
Page 18
stabilizer to allow the stabilizer to reach the change oil refer to the Maintenance section of carburetor. this manual. Do not drain the gas tank and carburetor if Clean engine using fuel stabilizer. Drain all the oil from the Clean engine and remove any grass clippings, crankcase (This should be done after the engine has been operated and is stillwarm) dirt, or chaff from the exterior of the engine.
Page 19
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION Engine fails to start 1. Blade control handle disengaged 1. Engage blade control handle. 2. Spark plug wire disconnected 2. Connect wire to spark plug. 3. Throttle control lever not in starting position 3. Move throttle lever to starting position. 4.
Page 20
SEARS CRAFTSMAN 5.5 H.P. LAWN MOWER MODEL 247.370320...
Page 25
CRAFTSMAN ENGINE NO. 143.975512 CRAFTSMAN 5.5 H.P, LAWN MOWER MODEL 247.370320 Part No. Part No. Description Description 32610A RPM High 3100 to 3400 Connecting Rod Bolt RPM Low 2000 to 2300 36030 Valve Lifter 36177 36031A Cylinder Camshaft (MCR) 27652...
Page 26
Fable continued from Page 25) Part No. Part No. Description Description 36153 35395 Blower Housing Spark Plug (J19LM) 650737 31672 Screw, 1/4-20 x 1/2" Valve Spring 650929 31673 Screw, 1/4-20 x 11/16" Lower Valve Spring Cap Starter Grill 151A 40016 Intake Valve Seal 263A 36156A...