Table of Contents
Advertisement
Panasonic Electric Works Nordic AB
MEW01349
Rev: -
8.2
Operating Instructions Fire alarm system EBL512 G3, V1.1.x
Alarm devices disabled
All programmable outputs of type "Alarm devices" are
disabled, i.e. they cannot be activated.
Alarm devices not disabled
All programmable outputs of type "Alarm devices" are
enabled, i.e. they can be activated.
If the inside switch is in its disabled state when the c.i.e. door is being
closed the buzzer will beep once and the message "
" will be shown in the display. For priority order see
left active
chapter "The information area priority order", page 22.
NOTE! The inside switch has no function if the outside switch (see
below) is activated (ON).
New Zealand FB Silence switch (outside
switch)
NOTE! The functions in this chapter are valid for the New Zealand
convention only.
The "New Zealand FB Silence switch" is also called the "outside
switch" since it is placed outside the c.i.e. The outside switch is a key
switch connected to a programmable input with the trigger condition
"New Zealand FB Silence switch".
The outside switch can be in two states.
The outside switch is turned ON (i.e. from not activated to activated
state).
All programmable outputs of type "Alarm devices" are
disabled, i.e. they cannot be activated. The "inside switch"
(see above) has no function.
LEDs "Fire" (L1) on the front changes from blinking to steady
(continuous).
The c.i.e. built-in buzzer is silenced.
A fault is generated:
active"
.
The outside switch is turned OFF (i.e. from activated to not
activated state).
The fault "
FAULT: FB Silence switch active"
Serviced
.
Any alarm point / zone in fire alarm state will automatically be
disabled / isolated. (I.e. it has to be re-enabled via menu
H2/B5.)
Any alarm point / zone in fire alarm state will automatically
change state to "Isolated alarm" and in the fire alarm list
29
Silence switch
"
FAULT:
FB
Silence
switch
will be
Advertisement
Table of Contents
