Table of Contents
Advertisement
Sealed Gas Cooktop (conL)
Electrical
requirements
Electrical Shock Hazard
Plug into a grounded 3-prong outlet.
Do not remove ground prong.
Oo not use an adapter.
Failure to follow these instructions
can
.result In death, fire, or electrical shock.
If codes permit and a separate ground wire is
used, It is recommended
that a qualified
electrician determine that the ground path is
adequate.
Do Not ground to a gas pipe.
Check with a qualified electrician if you ere
not sure the appliance is properly grounded.
Do Not have a fuse in the neutral or ground
circuit.
See back page for wiring diagram.
A 120-volt, 60-Hz, AC only, 15-ampere, fused
electrical supply is required. Time-delay fuse or
circuit breaker is recommended. It is
recommended that a separate circuit serving only
this appliance be provided.
Electronic ignition systems operate within wide
voltage limits, but proper grounding and polarity
is necessary. In addition to checking that the
outlet provides 120-volt power and is correctly
grounded, the outlet must be checked by a
qualified electrician to see if it is wired with
correct polarity.
A wiring diagram is provided on the bottom of the
cooktop box and in the literature package.
Recommended
ground
method
For your personal safety, this appliance must be
grounded. This appliance is equipped with a
power supply cord having a 3-prong ground plug.
To minimize possible shock hazard, the cord
must be plugged into a mating 3-prong ground-
type outlet, grounded in accordance with National
Electrical Code, ANSI/NFPA 70 -- latest edition
and all local codes and ordinances. See Figure 8.
If a mating outlet is not available, it is the
personal responsibility and obligation of the
customer to have a properly grounded 3-prong
outlet installed by a qualified electrician.
3-prong ground-
type outlet
3-pron_l .._
grouno
_I_I;'
tLI
"°°--WI
_["
ground
pewer_ltll
prong
supply
cord
Figure 8
o
Now start...
With cooktop
and/or grill in kitchen.
If installing more than one appliance in the same
cutout, work with one appliance at a time. Start
with the appliance that will be to the left side of
the cutout. Make all adjustments; then follow
steps to add adjacent appliances.
package from the side of the carton.
Remove pressure regulator and hardware
package from side of carton.
20
Advertisement
Table of Contents
