Table of Contents
Advertisement
Downdraft Vent (conL
'n:
cutout, go to Step 11.
If downdraft
vent will be installed in a
separate cutout (no other appliances
In same
cutout), remove the motor from the blower box.
Carefully insert the blower box into the
countertop cutout.
Lift motor up and place on blower box. Connect
the motor and power supply wiring as described
in Steps 11 - 16 and 18 - 21.
green
blac_
wires
114.]
Power supply
wiring Is not
provided.
_
brown capacitor
wires (Intemal
vent system
t
only)
t
wire
_
connector
_
:=_-whlte
wires
green
ground
_-
wires
a:pp%
cab,°
motor cable
0
0
0
II1.1
Use all four nuts to attach the motor to the blower
box. Use a 10 mm or 3/8" ratchet to tighten the nut
located inside the duct opening. Be sure to tighten
this nut or vibration may occur, causing noise
•during operation.
14
Thread wires from the motor conduit through
conduit connector and through the opening of the
wiring box. Tighten the conduit connector screws.
red wires
power
supply cable
- motor
cable
Connect the red wire from the motor to the red
wire from the control with a twist-on wire
connector.
Disconnect power supply. Thread the power
supply cable through the conduit connector.
Tighten the screws on the conduit connector.
Connect the two, white wires together with a
twist-on wire connector.
Connect the black wire from the power supply
cable to the black wire of the control with a twist-
on wire connector.
Connect the three, green ground wires together
with a twist-on wire connector.
rubber cap
[151 '"°°
terminal
•
Remove the rubber cap from the
capacitor. Thread the two, brown
wires with spade ,terminals through the rubber
cap of the capacitor. Attach one wire to one of
the inside capacitor terminals. Then attach the
Advertisement
Table of Contents
