Advertisement
TRIM SAW
315.114260
Blade Diameter
5-1/2 in.
Blade Arbor
3/8 in.
Cutting Depth at 0°
1-9/16 in,
Cutting Depth at 45 °
1-1/8 in.
No load Speed
4,500 RPM
Motor
19.2 Volt DC
CHARGER
Input
Charging Voltage
Charge Rate
BATrERY PACK
ITEM NO._9 11041
(1425301)
120 V, 60 Hz, AC only
19.2 Volt
1 Hours
ITEM NO. _ 11375
(1323517
and 1323903)
Yourtrim saw has been shipped completelyassembled
exceptfor the blade. Inspect it carefullyto make sure no
breakage or damage has occurredduring shipping. If any
parts are damaged or missing, contact your nearest Sears
Retail Store to obtain replacement parts before attempting
to operate saw.A blade, blade wrench (5 mm hex key), rip
guide (edge guide) and this operator'smanual are also
included.
WARNING:
If anyparts are missing,do not
operate yoursaw untilthe missing parts are replaced.
Failureto do so could resultinpossiblessrious per-
sonaJinjury.
The following recommended accassones are currentlyavailable at Sears Retail Stores.
•
5-1/2 in. Thin Kerr Blade
WARNING:
The use of attachments or accessoriesnot listed mightbe hazardous.
KNOW YOU R TRIM SAW
See Figure 1.
Beforeattemptingto use yourtrim saw, familiarize yoursoff
with all operatingfeatures and safety requirements.
Features includeeasily operated bevel cut and depthof
cut adiustment mechanisms;positive0° bevel stop;
spindlelock; and blade wrench storage.
" JkWARNING:
Donot
allow familiarity with your
saw to make you careless. Remember that a
careless fraction of a second is sufficientto inflict
severe injury.
SWITC H
Your saw is equippedwith a look-offbutton which reduces
the possibilityof accidental starting.The lock-offbut'_on is
located on the handle above the switchtrigger. You must
depressthe lock-offbutton in order to pull the switch
trigger.The lock resets eaoh time the trigger is released.
Nots: You can depress the lock-off buttonfrom eitherthe
left or rightside:
APPLICATIONS
(Use only for the purposes listed below)
•
Cuttingall types of wood products(lumber,plywood,
paneling).
Advertisement
