Advertisement
•
When making a cut use steady, even pressure,
Never force cuts.
•
Do not cut warped or wet lumber.
•
Always hold your saw firmly with both hands and keep
your body in a balanced
position
so as to resist the
forces of Idckback should it occur.
When using your saw, always stay alert and exercise
control.
Do not remove your sew from workplece
while the blade Is moving.
DEPTH
OF CUT ADJUSTMENT
Always keep correctblade depth setting. The correct
blade depth setting for all cuts should not exceed 1/4 inch
belowthe material to be cut. More blade depth will
increase the chance of kickback and cause the cut to be
rough.One blade tooth below the materialto be cut works
best for most efficientcutting action.
TO ADJUS'rBLADE
DEPTH
•
Remove battery packfrom saw.
WARNING:
Failure to remove battery pack from
saw could result in accidental starting causing
possibleserious personal injury.
STARTING
A CUT
Know the dght way to use your saw,
See Rgure 13.
Never use your sew as shown In figure 14.
Fig, 13
TORAISE
SAW
BASE
ASSEMBLY
TO
TO
LOWER SAW
TIGHTEN
DEPTH
TO
AI_USTIIIENT
LOOSEN
KNOB
Fig. 12
•
Loosen depth adjustment knob. See Figure 12.
•
Hold base flat against the workpiece and raise or lower
saw until the required depth is reached.
•
"13ghtendepth adjustment knob securely.
WRONG
Fig. 14
Never place your hand on the workpleoe behind your
sew while making a cuL
_. WARNING:
To make sawing easier and safer,
always maintain proper controlof yoursaw. Loss of
controlof your saw could cause an accidentresulting
in poss_le,sedous injury.
14
Advertisement
