Rechecking The Address Settings; Verifying The System Operation Using Supportwave - HP Model 705 - Workstation User Manual

Hp dds-2 tape drive user's guide (a1658-90701)

Hide thumbs Also See for Model 705 - Workstation:

Table of Contents

Troubleshooting and Removal/Replacement Procedures

Recheck the device list (see "Recheck the Address Settings" below).

Rechecking the Address Settings

Check the address settings again to see if the drive is now listed (see "Checking the

Address Settings for Single-Ended Drives," earlier in this chapter).

If the DDS-2 drive and all other SCSI-2 devices available to you before you installed the

DDS-2 drive are now listed, run the system verification test for your software version, as

explained in the next sections.

If the DDS-2 drive is still not listed, or one of the SCSI-2 devices available to you before

you installed the DDS-2 drive is still not listed, contact your service representative.

HP-UX uses a diagnostics product called SupportWave. SupportWave contains the

Support Tools Manager so that you can verify your system operation.

You can access the Support Tools Manager while in a terminal window. If you are using

HP VUE as your interface, you can also access the Support Tools Manager through the

sys_admin directory.

Three interfaces are available with the Support Tools Manager: a command line interface

(accessed through the cstm command), a menu-driven interface (accessed through the

mstm command), and the graphical user interface (accessed through the xstm

command).

For more information on SupportWave user interfaces, see the online man pages by

entering the following at a command line prompt:

# man cstm

# man mstm

# man xstm

3–6

RETURN

Table of Contents

Show Quick Links

Table of Contents