Introduction
Preparing to Install the DDS-2 Drive
The following information describes how to prepare the DDS-2 drive for installation.
Tools Required
The following tools are needed to install the DDS-2 drive:
#2 Phillips screwdriver
Small needle-nose pliers
T10 torx wrench
Verifying Kit Contents
Verify that the kit contains one of each of the following:
DDS-2 drive (manufacturing part number 0950–2658)
Set of 4 screws (M4x6)
Set of two expansion brackets and four screws (M3x6 T10) (not included in all kits)
Power adapter cable
SCSI I/O cable
Static strap
HP DDS-2 Tape Drive User's Guide (A1658–90701)
NOTICE:
If any contents of your kit are missing, contact your sales
representative.
Operating System Support
The HP DDS-2 drive supports HP-UX 9.05 and later. This drive requires the following
HP-UX patches (or their replacements): PHKL_7852 and PHSS_7587. Both patches are
for OS versions 9.x only and cannot be used on any 10.x OS versions.****
1–6