Exit Hp Diagtools And Take Corrective Action If Necessary; Reinstall Your Nos; Prepare Your Boot Drive - HP D7171A - NetServer - LPr Upgrade Manual

Hp netserver lh 3000/3000r to lh 6000/6000r upgrade guide

Hide thumbs Also See for D7171A - NetServer - LPr:

Table of Contents

Chapter 5

Exit HP DiagTools and Take Corrective Action if Necessary

1. Press F3 to exit HP DiagTools from the Advanced System Tests menu or

from any of the Basic System Test screens.

2. Remove the HP DiagTools diskette.

3. If you need to take corrective action, be sure to power down the NetServer

before you remove covers.

4. If you need to contact an HP customer support representative, save your

Support Ticket diskette.

It is essential that you reinstall your NOS. Reinstalling your NOS ensures that you

get all capabilities of your new NetServer and ensures that PCI IDs are reassigned

correctly. PCI IDs are different between the NetServer LH 3000/3000r and the

LH 6000/6000r.

Reinstalling your NOS has two parts:

Prepare your boot drive by either repartitioning it, or by reinitializing your

boot logical drive.

Install your NOS and configure your NetServer.

Before you reinstall your NOS, you must repartition your boot drive or, if your

boot drive is on a HP NetRAID logical drive, you must reinitialize your boot

logical drive.

If Your Boot Drive is Connected to a SCSI Controller

If your boot drive is connected to a SCSI controller, and is not on a NetRAID

logical drive, you should clear your boot drive as follows:

1. Delete all partitions on your boot drive.

2. Repartition the drive.

Updating Firmware

Table of Contents