HP D7171A - NetServer - LPr Manual page 7

Rack cabling reference

Hide thumbs Also See for D7171A - NetServer - LPr:

Table of Contents

Chapter 1

Prepare Rack Enclosures for Assembly

WARNING

A tip-over hazard exists. Rack enclosures are shipped upright

and are top-heavy. Never move enclosures without adequate

equipment and assistance. Use caution to prevent rack from

falling over and causing potential damage or injury.

If you receive pre-configured units, follow assembly instructions from the

supplying organization first, if you have them. Otherwise, continue with this set

of instructions.

Move Rack Enclosures and Other Units to Installation Location

WARNING

Whenever you lift equipment, limit the amount of weight

each person picks up. Lift with your legs, not with your back.

Use two or more people and the proper equipment to move the rack enclosure,

server, mass storage units, and other components. Stage cartons a few feet from

your assembly and final power-up location.

Unpack Rack Enclosures and Hardware, Use Anti-Tip Measures, and Remove the

Shipping Panels

WARNING

Use care in moving the rack down from the pallet. Three

people are required for this step.

1. Follow pictorial instructions on the outside of the shipping container to

unbox the rack enclosure.

2. Adjust the leveler feet, when present, under each of the four corners of

each rack. Lower each leveler foot to be in firm contact with the floor.

CAUTION

The leveler feet prevent the rack from rolling away from you

when you install components. Be sure they have been lowered

before you put anything into the rack.

3. Find and extend the anti-tip foot under the rack (or bolt on the anti-tip

mechanism, if included) before you mount any rack equipment on slides.

About This Cabling Reference

Table of Contents