Solving Memory Problems - HP Xw4600 - Workstation - 2 GB RAM Technical Reference Manual
Hp xw4600 workstation - service and technical reference guide
Hide thumbs
Also See for Xw4600 - Workstation - 2 GB RAM:
- Service and technical reference manual (176 pages) ,
- Specification (73 pages) ,
- Quickspecs (68 pages)
Table of Contents
Advertisement
Table 6-12
Network problems (continued)
Network controller stops working
without apparent cause.
New network card does not boot. New network card might be
Cannot connect to network
server when attempting remote
system installation.
Computer Setup (F10) Utility
reports unprogrammed
EEPROM.
Solving memory problems
CAUTION:
nonECC memory. The operating system does not boot with mixed-ECC memory.
Table 6-13
System does not boot (or does not
function properly) after installing
additional memory modules.
Out of memory error.
Memory count during POST is
wrong.
Insufficient memory error during
operation.
Power LED flashes red 5 times
(once every second), followed by a
2-second pause, and then the
workstation beeps 5 times.
126 Chapter 6 System diagnostics and troubleshooting
Problem
The files containing the network
drivers are corrupted.
The cable is not securely
connected.
The network controller is
defective.
defective or might not meet
industry-standard specifications.
The network controller is not
configured properly.
Unprogrammed EEPROM.
For those systems that support ECC memory, HP does not support mixing ECC and
Memory problems
Problem
A memory module is not the
correct type or speed or the
new memory module is not
seated properly.
Memory configuration might
not be set up correctly.
You have run out of memory to
run the application.
The memory modules might
not be installed correctly.
Too many Terminate and Stay
Resident (TSR) programs are
installed.
You have run out of memory
for the application.
Memory is installed incorrectly
or is bad.
Cause
Reinstall the network drivers using the Restore Plus! CD.
Be sure that both ends of the cable are securely attached
to the correct devices.
Replace the NIC.
Install a working, industry-standard NIC, or change the
boot sequence to boot from another source.
Verify network connectivity, that a DHCP server is
present, and that the Remote System Installation Server
contains the NIC drivers for your NIC.
Flash the ROM.
Cause
Replace module with the correct, industry-standard device
for the workstation.
On some models, ECC and nonECC memory modules
cannot be mixed.
Use the Device Manager to verify memory configuration.
Review the application documentation to determine the
memory requirements.
Verify that the memory modules have been installed
correctly and that proper modules are used.
Delete any TSRs that you do not need.
Verify the memory requirements for the application or add
more memory to the workstation.
1.
Reseat DIMMs.
2.
Replace DIMMs one at a time to isolate the faulty
module.
3.
Replace third-party memory with HP memory.
4.
Replace the system board.
Solution
Solution
ENWW
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
