Processor Heatsink; Removing The Processor Heatsink - HP Xw4600 - Workstation - 2 GB RAM Technical Reference Manual
Hp xw4600 workstation - service and technical reference guide
Hide thumbs
Also See for Xw4600 - Workstation - 2 GB RAM:
- Service and technical reference manual (176 pages) ,
- Specification (73 pages) ,
- Quickspecs (68 pages)
Table of Contents
Advertisement
5.
Connect the data cable to the hard drive (1) and to the system board (2).
Figure 5-58
6.
Connect the power cable (not shown).
Processor heatsink
This section describes how to remove and install a processor heatsink.
NOTE:
Not all heatsinks are the same. Therefore, the heatsink shown in the following figures is an
example of what might be installed in your workstation.
Removing the processor heatsink
To remove a heatsink:
1.
Power down the workstation
workstation
(Removing the side access panel on page
ENWW
Connecting the data cable
(Predisassembly procedures on page
(Predisassembly procedures on page
57), and then remove the side access panel
61).
Removing and replacing components 101
57), disconnect power from the
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
