Ip Igmp Snooping Mrouter-Time-Out - Dell PowerEdge M420 Reference Manual
Dell powerconnect m6220/m6348/m8024/m8024-k cli reference guide
Hide thumbs
Also See for PowerEdge M420:
- Configuration manual (1246 pages) ,
- Getting started manual (202 pages) ,
- Owner's manual (121 pages)
Table of Contents
Advertisement
IGMP leave was received from a specific port, the current port is deleted from
the member list of that Multicast group. To configure the default leave-time-
out, use the no form of this command.
Syntax
ip igmp snooping leave-time-out [
no ip igmp snooping leave-time-out
time-out — Specifies the leave-time-out in seconds. (Range: 1-25)
•
immediate-leave — Specifies that the port should be removed
•
immediately from the members list after receiving IGMP Leave.
Default Configuration
The default leave-time-out configuration is 10 seconds.
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet)
mode
User Guidelines
The leave timeout should be set greater than the maximum time that a host
is allowed to respond to an IGMP Query.
Use immediate leave only where there is only one host connected to a port.
Example
The following example configures the host leave-time-out to 15 seconds.
console(config-if-1/0/1)#ip igmp snooping leave-time-
out 15
ip igmp snooping mrouter-time-out
Use the ip igmp snooping mrouter-time-out command in Interface
Configuration mode to configure the mrouter-time-out. This command is
used for setting the aging-out time after Multicast router ports are
automatically learned. To reset to the default mrouter-time-out, use the no
form of this command.
time-out
| immediate-leave]
IGMP Snooping Commands
441
- Quick Links:
- Table of Contents
- Ethernet Configuration
Hide quick links:
Advertisement
Chapters
Table of Contents
