Speaker
The speaker is secured to the front of the chassis between the fan and the I/O ports.
1.
Prepare the computer for disassembly
2.
Remove the computer access panel
3.
Remove the front bezel
4.
Disconnect the speaker cable from the white system board connector labeled SPKR.
5.
On the outside of the chassis, remove the two torx T8 screws that secure the speaker to the
chassis, and then from the inside of the chassis, slide the speaker up to remove it.
Figure 7-31
To install the speaker, reverse the removal procedure.
118
Chapter 7 Removal and Replacement Procedures Ultra-Slim Desktop (USDT) Chassis
(Preparation for Disassembly on page
(Computer Access Panel on page
(Front Bezel on page
Removing the speaker
100).
92).
99).