Installing the New Optical Drive
NOTE:
If you are installing an optical drive in a bay that did not previously have a drive in it, you
must remove the access panel and the bezel blank covering the opening of the bay before proceeding.
Follow the procedures in
1.
Attach the release latch to the new optical drive. Refer to
on page
2.
With the back of the optical drive facing the computer and the release latch on the inner side of
the drive, align the drive with the opening in the front bezel.
3.
Slide the optical drive through the front bezel all the way into the bay so that it locks in place (1),
then connect the cable to the rear of the drive (2).
Figure 7-18
Computer Access Panel on page 99
108.
Installing the Optical Drive
and
Bezel Blank on page
Preparing the New Optical Drive
Replacing the Optical Drive
101.
109