Editing The Default Fibre Channel Host Port Settings - HP 12000 User Manual
Hp 12200 gateway virtual library system user guide (bw403-10001, june 2011)
Hide thumbs
Also See for 12000:
- User manual (266 pages) ,
- Manual (218 pages) ,
- Design manual (160 pages)
Table of Contents
Advertisement
Set the frequency at which the system state is checked and the browser is refreshed
Add the VLS administrator's name, company, mail, and phone number, and the VLS location
to the Identity tab window
Set the maximum number of notification alerts to store
To set the user preferences, from Command View VLS:
1.
From the System tab, select Chassis in the navigation tree.
2.
Click User Preferences under Maintenance Tasks. The User Preferences window opens.
3.
Enter a value (in seconds) in the State Polling Frequency box.
The default state polling frequency is 15 seconds.
4.
Enter the appropriate numeric value in the Number of Notifications dialog box.
5.
Enter the company name in the Company dialog box.
6.
Enter the city and state where the VLS is located in the Location dialog box. This is displayed
on the Identity tab.
7.
Enter the VLS administrator's name in the Contact dialog box. This is displayed on the Identity
tab.
8.
Enter the VLS administrator's phone number, including area code, in the Contact Phone dialog
box. This is displayed on the Identity tab.
9.
Enter the VLS administrator's E-mail address in the E-mail dialog box. This is displayed on the
Identity tab.
The E-mail address entered is assigned to the Email Administrator link on the Login window.
Users can click this link to send an E-mail to the administrator when they need help or are
unable to log in to Command View VLS.
10. Enter the warranty serial number in the Warranty Serial Number dialog box. This is displayed
on the Identity tab and is saved and restored as part of the VLS device configuration.
1 1. Click Apply Settings.
Editing the Default Fibre Channel Host Port Settings
Only edit the Fibre Channel host port settings if you do not want to use the default settings, if some
system problem is occurring, or if the "AUTO" setting is not working properly.
NOTE:
The values displayed under Actual are the actual values found by the VLS for the Fibre
Channel host port.
NOTE:
If you enter a value that is not supported by the Fibre Channel port (for example, you
enter Fabric in the Topology column but the port uses the Loop topology), your entry remains in
the Preferred box, but the Actual column will display the correct value when Command View VLS
performs its occasional status checks.
To change the default Fibre Channel host port settings, from Command View VLS:
1.
Click the System tab.
2.
Expand Chassis in the navigation tree.
3.
Expand the Node to modify in the navigation tree.
4.
Select Fibre Channel in the navigation tree.
The Fibre Channel Host Ports window opens
(Figure 14 (page
88)).
Editing the Default Fibre Channel Host Port Settings
87
Advertisement
Table of Contents
