Web Configuration - D-Link DWL-810 Owner's Manual
2.4ghz ethernet-to-wireless bridge
Hide thumbs
Also See for DWL-810:
- User manual (64 pages) ,
- Quick installation manual (8 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
5.
Web Configuration
Configuration is required only if you will be using the DWL-810 in
Infrastructure mode. If you will be using the DWL-810 in Infrastructure mode
or if you need to configure the DWL-810, please consider the following
before using the Web Configuration:
You will need a JavaScript-enabled web-browser such as the Internet
Explorer 4.0 or higher, or the Netscape Navigator 4.0 or higher.
The computer that you are using for initial configuration must have
an IP Address within the same range as the IP Address of the DWL-
810. The DWL-810 has a default IP Address of
subnet mask of 255.255.255.0
You will need to assign a Static IP Address to the computer that you are
using to configure the DWL-810, within the IP Address Range of the DWL-
810. For example, you can assign a Static IP address of 192.168.0.2 with
a subnet mask of 255.255.255.0 (Please refer to the Appendix section of
the Quick Installation Guide.)
Factory Default Settings for the DWL-810
Operating Mode
SSID
Channel
Transmission rates
WEP enable
Administrator password
IP Address mode
IP Address
IP Subnet
username
No Configuration is needed when you use
the DWL-810 in Ad-Hoc Mode (Setup #1.)
Ad-Hoc
default
6
Auto
No
Blank (no password needed)
Static
192.168.0.30
255.255.255.0
admin (all lower case)
12
192.168.0.30
with a
Advertisement
Table of Contents
