Table of Contents
Advertisement
Troubleshooting
Guide
Dishwashers
may occasionally
exhibit
problems
that are unrelated
to a malfunction
of the dishwasher
itself. The
following
information
may help you with a dishwasher
problem
without
involving
a repair professional.
Dishwasher
does not
start
1. Door
may not be properly
latched.
2. Unit
may not be turned
on.
3. Unit
not reset
or previous
cycle
not com-
pleted.
4. Delay
start
engaged.
5. Interruption
of electrical
power
supply
to
dishwasher
or blown
fuse.
6. The door
may have been closed
without
first
selecting
a cycle.
7. Water
supply
may not be turned
on.
1. Shut the door completely.
2. Press the main power switch
to turn unit
on.
3. To reset, refer to "Operating
the Dish-
washer"
in this manual.
4. To reset, refer to "Delay Start" section
in
this manual.
5. Check circuit
breaker.
6. Select a cycle and press start.
7. Check and turn on water supply.
Dishwasher
beeping
(end of cycle
signal)
1.Default factory settings alert the customer
that the cycle is complete
by beeping.
This
feature can be deactivated
if so desired.
2. Water connection
is lost.
1. To adjust the volume or deactivate,
refer to
the "Cycle Completion
Signal" section
in this
manual.
2. Check and turn on water supply.
Display does
not illumi-
nate or con-
sole lights
are not on
1. A fuse may have been blown or circuit
breaker tripped.
2. Door not closed or latched.
1. Check the fuse or circuit
breaker
box and
replace the fuse or reset the breaker
if neces-
sary.
2. Ensure door is properly
latched and com-
pletely closed.
Dishwasher
seems to run
a long time
1. Incoming
water is not warm enough.
2. Cycle time can vary due to soil and water
conditions.
3. Rinse aid dispenser
is empty.
4. Dishwasher
connected
to cold water sup-
ply.
Note: Refer to "Wash Cycle information"
sec-
tion in this manual for typical
cycle lengths.
1. Before starting
a cycle, run hot water fau-
cet at the sink closest to the dishwasher.
2. Sensors in the dishwasher
automatically
increase the cycle time to ensure a good
wash when heavy soil is detected.
3. Add rinse aid.
4. Verify dishwasher
is connected
to hot
water supply plumbing.
Dishes are
not getting
clean
enough
1. Spray arm movement
obstructed.
2. Spray arm nozzles clogged.
3. Improper
use of detergents.
4. Filters could be clogged.
5. Dishes are nested or loaded too close
together.
6. Selected
wash cycle is not suitable
for
food soil conditions.
1. Ensure that spray arm movement
is not
blocked
by hand rotating
spray arms before
starting
cycle.
2. Remove the spray arms and clean accord-
ing to the "Care and Maintenance"
section
of
the manual.
3. Increase or decrease
detergent
depending
on the water hardness
(refer to Table 1).
4. Clean the filters
according
to the "Care and
Maintenance"
section
of the manual.
5. Rearrange
load such that water spray can
reach all items in the dishwasher-
see "Load-
ing the Dishwasher"
section
of the manual.
6. Refer to "Wash Cycle Information"
section
of the manual.
19
Advertisement
Table of Contents
