Table of Contents
Advertisement
IdeaShare
User Guide
Step 4 Tap Share on the meeting page as shown in
projection.
Figure 3-4 Sharing in a meeting
----End
Wi-Fi P2P Projection
Introduction
Wi-Fi P2P is also called Wi-Fi Direct. Through this protocol, two devices supporting
Wi-Fi can establish a direct, peer-to-peer connection without passing through the
LAN.
The IdeaShare client supports projection using Wi-Fi P2P. You can enter the
projection code to start projection as long as Wi-Fi is enabled on both the
endpoint and your computer (or mobile phone).
Wi-Fi P2P Projection Procedure
Step 1 Ensure that Wi-Fi is enabled on the endpoint and computer (or phone).
Step 2 On the endpoint's home screen, tap Projection. On the displayed screen, choose
P2P Projection, as shown in
Issue 01 (2023-03-30)
NO TE
● This function applies only to IdeaHub S2, IdeaHub S2 Pro, IdeaHub ES2, and IdeaHub
ES2 Pro that support the Wi-Fi function.
● Wi-Fi P2P projection must meet the following operating system requirements:
●
Computer: 32-bit and 64-bit Windows 10 or 11
●
Mobile phone: Android 8.0 or later; HarmonyOS 2.0 or later
●
IdeaShare client: V6.19.0.32 or later
> Advanced > Wi-Fi P2P Projection in the upper right corner to enable Wi-Fi
NO TE
The Wi-Fi P2P configuration item in the advanced projection settings applies only to
IdeaHub S2, IdeaHub S2 Pro, IdeaHub ES2, and IdeaHub ES2 Pro of version 2.1.0 and later.
Copyright © Huawei Technologies Co., Ltd.
Figure
Figure
3-5.
3 Projection Function
3-4, and then share wireless
9
Advertisement
Table of Contents
