Table of Contents
Advertisement
en-us Appliance care
Remove the stopper from the recess in the top
1.
insert it in the underside
When the appliance is delivered, the stopper is included
as an accessory in the scope of delivery.
Clean the filter in the condensation container.
2.
16.2 Calling up the appliance care program
Requirement: The appliance care program is ready.
→ Page 25
Press .
1.
The switch-on process takes a few seconds.
Press Basic Settings.
2.
Set the program to position 5.
3.
a "CP1" and the program duration alternate on the
display.
16.3 Running the basic appliance care
program
To remove light dirt deposits in the appliance, you can run
the basic appliance care program.
Notes
¡ The basic appliance care program runs for
approximately 1 hour.
¡ After a lengthy period of use, the appliance reminds you
to run the basic appliance care program. Before the
program starts or after the program has ended, the
display shows the notification "CArE". This notification
appears repeatedly until you have run the basic
appliance care program through to the end.
Requirements
¡ The appliance care program is ready. → Page 25
¡ The appliance care program is called up. → Page 26
Pour approx. 6.3 cups (1.5 l) of hot mains water into the
1.
condensation container.
Hold the filled condensation container level so that no
liquid spills out.
Insert the condensation container so that it locks into
2.
place.
Press
.
3.
26
and
.
a The appliance care program starts and a signal tone
sounds.
a "End" appears on the display and a signal tone sounds
once the appliance care program has ended.
Pull out the condensation container horizontally and
4.
empty it.
If you drain the condensation using the drain hose,
5.
remove the stopper from the underside of the
condensation container and insert it into the recess in
the top of the condensation container. → Page 25
Insert the condensation container so that it locks into
6.
place.
Put the appliance into standby mode. → Page 20
7.
16.4 Running the intensive appliance care
program
You can run the intensive appliance care program to
remove any stubborn dirt deposits in the appliance and
odors after a downtime of more than one month.
Notes
¡ The intensive appliance care program runs for
approximately 4 hours and must not be canceled.
¡ When you run the intensive appliance care program,
you need the original appliance care product
→ Page 19 .
Starting the intensive appliance care program
Requirements
¡ The appliance care program is ready. → Page 25
¡ The appliance care program is called up. → Page 26
Press
.
1.
a "CP2" and the program duration alternate on the
display.
Pour a bottle of the appliance care product and approx.
2.
6.3 cups (1.5 l) of hot mains water into the condensation
container.
Hold the filled condensation container level so that no
liquid spills out.
Insert the condensation container so that it locks into
3.
place.
Press
.
4.
a The appliance care program starts and a signal tone
sounds.
a After around 3 hours, the appliance pauses the
appliance care program and the remaining program
duration flashes on the display.
Pull out the condensation container horizontally and
5.
empty it.
Pour approx. 6.3 cups (1.5 l) of hot mains water into the
6.
condensation container.
Carefully swivel the condensation container horizontally
7.
and empty it to rinse out any remaining appliance care
product.
Advertisement
Table of Contents
