Table of Contents
Advertisement
(Digital Scanner)
Tracing the Bar Codes
The "Beep"
sound indicates
that the bar code
was read
completely.
Trace the bar code
Bar Code
completely past the last bar,
gets dirty or scratched, the bar code reading may
become impossible.
@Protect the Remote Controller from strong shocks
and vibration. Keep it away from water and places
with high temperature and humidity.
elf the bar code is traced slowly, it cannot be read
correctly.
@When there is no "Beep" sound, the reading of the
bar code is incomplete. Always check your Display
Window to confirm the function scanned has been
accepted.
@When using the Programming Sheet, put it on flat
surface: Reading the bar codes while holding it in
your hand or bending it, may result in incorrect op-
eration.
@Do not deviate from the bar code, nor stop tracing
halfway.
Load the batteries as follows:
(1) Push back the battery compartment locking lever.
©
Replace the lid.
Note:
Direct suntight may interfere with the beam.
Recommendation
Advertisement
Table of Contents
