Table of Contents
Advertisement
Transmit the Programming Data
Keep pressing the Transmit Button and confirm that the
programmed data on the Multi-Function Display of the VTR
are as desired.
After releasing the dutton, the data will continue to be dis-
played for about 12 seconds.
"Beep-beep-beep-beep-
beep..." sound indicates
programming is completed.
elf the
transmission
was
not
received
correctly,
the
"Beep-Beep, Beep-Beep" sound from the VTR will warn
you. In this case, perform transmission again.
e@The transmission is possible when the VTR is turned on
but is not in any of the recording or playback operation
modes. It is also possible when the VTR is in the timer
recording standby mode ([Q indication is lit).
@ The programming will be done on the next lower unoccu-
pied timer programme number (8~ 1).
elf all programme numbers are occupied, the "Beep-Beep,
Beep-Beep" sound from the VTR will warn you that the
programming cannot be made.
When the Transmit Button is pressed, the VTR will auto-
matically be put into the timer recording standby condition
and the VTR will be turned off.
To
operate the VTR before the timer recording will be
performed, press the Timer Record Button to suspend the
timer recording standby condition. After using the VTR, be
sure to press the Timer Record Button again, otherwise
the timer recording will not be made.
27
Timer On/Off
After programming a timer recording, the VTR is in the timer
recording standby mode and cannot be used for any other
operation, such as playback. If some other operation is
desired, first trace the "TIMER
ON/OFF" bar code and
transmit it to the VTR with the Transmit Button.
TIMER ON/OFF
Repeat the following operation steps @-©.
@
Trace the "CANCEL" bar code on the Programming
Sheet.
@ Trace the bar codes
for "CHANNEL",
"DATE",
"START TIME" and "END TIME".
© Confirm that the present time is displayed on the
Multi-Function Display of the VTR, and transmit the
data.
elf the next timer programming data are transmitted
while the previous timer programming data are still
being displayed, the displayed timer recording data
will be cancelled.
:
Advertisement
Table of Contents
