Table of Contents
Advertisement
BASIC OPERATIONS
Recording can be performed on Deck !I only. Recording
is not possible on Deck |. You can make a recording of
a source which has been processed with the sound field
processor (or the sound image controller).
1. Press the eject button ( 4 ), and load the tape
for recording into Deck Hl.
@
Check to see that the accidental erasure preven-
tion tabs are not broken off.
@
Wind the tape forward past the leader to the start
of the magnetic coated portion.
2. Select the REV MODE switch.
==:
When
recording on one side of a tape.
=>
and e>:
When recording on one side of the tape
and then on the other (from forward to
reverse direction only).
3. Set the DOLBY NR switch to the desired po-
sition.
"@ A tape which has been recorded Using the DOLBY
NR system must be played back with the same
type.
4. Use the FUNCTION
button on the receiver to
select the recording source.
Program source
indicator
Radio broadcast
Operate the turntable.
LaserDisc
Record
Equipment which
is connected to
VCR/DAT jacks
Operate
the
equip-
ment connected to
VCR/DAT jacks.
VCR/DAT
5. Press the REC PAUSE button (@ If).
@ The recording indicator lights.
@ The direction indicator flashes.
@ When the APSC function is operated, recording is
performed while automatically setting the optimum
recording level.
6. Press the appropriate play button (Por <4).
The receiver display section will function to show the
elapsed recording time.
@
Next, begin playback of the component selected
for recording in step 4.
7. Play the recording source.
8. To stop recording, press the stop button (
Mf).
@ The FUNCTION button cannot be switched during
recording.
@ This unit's recording level has been previously set,
but the APSC (Auto Peak Search Control) is provid-
ed to allow even better recording results.
NOTE
Even if the SUPER P. BASS is set ON, recording is per-
formed in the OFF position.
40
<ARE1252>
En/Fr
OPERATIONS DE BASE
Un enregistrement ne peut étre effectué que sur la pla-
tine Il. L'enregistrement n'est pas possible sur la platine
|. L'enregistrement d'une source qui est passée par le pro-
cesseur de champ sonore (ou le contréle de relief sonore)
est également possible.
@ Vérifier que la languette de protection contre |'effa-
cement. accidentel n'est pas brisée.
®
Enrouler ja bande vers |'avant au-dela de |'amorce
jusqu'au début de la portion magnétique.
2. Sélectionner le commutateur de mode d'inver-
sion (REV MODE).
en
==
: Lors de l'enregistrement sur une face de la
bande.
la bande, puis sur l'autre (de la direction
avant a la direction arriére seulement).
3. Régler le commutateur DOLBY NR sur la posi-
tion désirée.
@
Une bande qui a été enregistrée en utilisant le
systéme DOLBY NR doit étre reproduite en utili-
sant le méme type.
Indicateur
Opération
sélectionné
Emission de
TUNER
| Syntoniser
radio
l'émission.
Source de
programme
cD
Reproduire le disque
compact
compact.
LaserDisc
LD
Reproduire le
LaserDisc
Disque
PHONO | Utiliser la table de
lecture.
VCR/DAT | Faire fonctionner
l'appareil branché aux
prises VCR/DAT.
Appareil bran-
ché aux prises
VCR/DAT
Advertisement
Table of Contents
