Advertisement
Available languages
Available languages
Tips for Better Cutting
The following recommendations should be used as a guide
(Recommended Cutting Positions). Results may vary with the
operator and the particular material being cut.
•
Never twist the band saw blade during cutting operation.
•
Never use liquid coolants with portable band saws.
Use of liquid coolants will cause build‑up on tires and
reduce performance.
•
If excessive vibration occurs during the cut, ensure that the
material being cut is securely clamped down. If vibration
continues, change the band saw blade.
•
Always keep at least 2–3 teeth engaged in the cut.
Recommended Cutting Positions
YES
YES
YES
MAINTENANCE
Your power tool has been designed to operate over a long
period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and
regular cleaning.
WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.
The charger and battery pack are not serviceable.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
Ventilation slots can be cleaned using a dry, soft non‑metallic
brush and/or a suitable vacuum cleaner. Do not use water or
NO
any cleaning solutions. Wear approved eye protection and an
approved dust mask.
Optional Accessories
NO
Consult your dealer for further information on the
appropriate accessories.
Tool Connect™ Chip (Fig. J)
Your tool is Tool Connect™ Chip ready and has a location for
installation of a Tool Connect™ Chip.
Tool Connect™ Chip is an optional application for your
smart device (such as a smart phone or tablet) that connects
the device to utilise the mobile application for inventory
management functions.
Refer to Tool Connect™ Chip Instruction Sheet for
more information.
Installing the Tool Connect™ Chip
1. Remove the retaining screws
2. Remove the protective cover and insert the Tool Connect™
3. Ensure that the Tool Connect™ Chip is flush with the
4. Refer to Tool Connect™ Chip Instruction Sheet for
WARNING: Electrical shock and mechanical hazard.
Disconnect the electrical appliance from the power source
before cleaning.
WARNING: To ensure safe and efficient operation,
always keep the electrical appliance and the ventilation
slots clean.
WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
WARNING: Since accessories, other than those offered
by D
WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.
Connect™ Chip protective cover
Chip into the empty pocket
housing. Secure it with the retaining screws and tighten
the screws.
further instructions.
EnGLIsh
WALT-recommended
e
22
that hold the Tool
21
into the tool.
23
.
39
Advertisement
