Table of Contents
Advertisement
b Meter icons
These function identically to the meter icons in the status
viewer.
c Property tabs
These consist of the [Utility] tab and tabs for channels 1
and 2.
For details on the setting items in each tab, see "[Utility]
tab" on page 45 and "Channel tabs 1/2" on page 45.
d [Close] button
Closes the [Property] window.
[Utility] tab
Displays setting items that are equivalent to those in the
UTILITY menu of the receiver.
For details on each setting item, refer to the Operating
Instructions supplied with the receiver.
Receiver Type: In online mode, this displays the device
information acquired from the receiver and cannot be
changed. The device information can be changed in offline
mode.
Receiver Model: In online mode, this displays the
frequency band acquired from the receiver and cannot be
changed. The frequency band can be changed in offline
mode. Specify a frequency band that corresponds to the
actual device.
Receiver Name: Sets a name for the receiver.
Band Block: Selects the frequency band to use (the largest
is 72 MHz).
Note
This function is not supported by the DWR-R01D and
DWR-R02D.
Band: Selects the frequency band to use.
ANT ATT: Sets the attenuator for the receiver's antenna
input.
ANT DC Output: Sets the DC power supply for the
antennas connected to the receiver's ANTENNA a/b IN
connectors.
Sync Source: Sets the sync signal source for the receiver.
Delay Adjust: Selects whether to correct differences in
audio delay time that may occur between receiver channels
1 and 2.
Alert function settings: Specifies the conditions under
which to light the ALERT indicator on the receiver. You
can select the following conditions as triggers for lighting
the ALERT indicator.
• RF low (RF level too low)
• RF over (RF level too high)
• QL low (QL too low)
• AF Peak (audio output level too high)
• Transmitter Battery low (remaining battery on
transmitter is low)
• Encryption unmatch (password or encryption key for the
encrypted communication function does not match)
• External word sync unlock (external word clock signal
not synchronized)
• Code mode unmatch (codec modes of transmitters and
receivers do not match)
Note
If lighting of the ALERT indicator is disabled for an item,
warning messages will not be displayed in the [Message
Log] tab or in the alert list under the [RF Chart Grapher]
tab of Wireless Studio for that item. In addition, such items
will not be recorded in the log file.
QL Alert SENS: Specifies the level at which the quality
of the received signal is determined to be low. If the the
quality of the received signal drops below the level
specified here, the ALERT indicator of the digital wireless
receiver lights.
Note
The QL Alert SENS function is available for the following
receiver versions.
DWR-R01D: Version 1.29 or later
DWR-R02D: Version 1.09 or later
DWR-R02DN: Version 1.14 or later
Channel tabs 1/2
Displays setting items that are equivalent to those in the
RECEIVER, TRANSMITTER, and RF REMOTE menus
of the receiver.
For details on the setting items in each menu, refer to the
Operating Instructions supplied with the receiver.
45
Advertisement
Table of Contents
