Table of Contents
Advertisement
Start-up
Contents of this chapter
This chapter describes the start-up procedure of the drive.
Start-up procedure
1. Only qualified electricians are allowed to start-up the drive.
2. Make sure that the installation of the drive module has been checked according to the
checklist in chapter
ready for start.
3. Perform the start-up tasks instructed by the cabinet-installer of the drive module.
4. Switch the power on, setup the drive control program, and perform the first start of the
drive and motor. See the ACS530-04 quick installation (3AXD50000810383 [English])
or ACS530 firmware manual (3AXD50000728268 [English]). If you need more
information on the use of the control panel, see ACS-BP-S Basic control panels user's
manual (3AXD50000048685 [English]).
For drive modules in which the Safe torque off function is in use: Test and validate the
operation of the Safe torque off function. See section
page 147.
Installation checklist,
and that the motor and driven equipment are
9
Start-up including acceptance test
Start-up 101
on
Advertisement
Table of Contents
