Advertisement
Connecting
an Antenna
to a Cable Box and VCR,
Connecting
Audio/Video
to the Cable Box or VCR
Note: The TV hack panel and connections
shown
here are for reference
only and may vary by model,
Contact
your local cable or satellite
provider
or refer to the cable
box or satellite
Owner's
Guide for
I
instructions
on optimal
connections
to this TV°
/
TV back
detail
Incoming
Cable
_
D
Cable
Box
Rear Terminals
@
VCR
back
panel .................................................................................................
:
i
Cable Box
(Figure 5)
1.
Connect
the incoming
cable to ANT-A on the TV
back panel.
Connect
three
coaxiam cabmes as fommows:
2.
One from LOOP-OUT
on the TV back panel to IN
on the back of the cable
box.
3.
One from OUT on the back of the cable box to
ANTENNA
IN on the VCR back panel.
4.
One from ANTENNA
OUT on the VCR back
panel to ANT-B
on the TV back panel.
Note:
For best performance,
please see Composite
Video with Audio or S-Video
with Audio,
below.
Figure 5. Connecting
the VCR with cable box.
TV back
panel
(section
detail)
(Recommended
if available)
VCR back
panel
i
Attach
only
one
cable
type
channel
or RF ON/OFF
i
switch,
set to OFE
(
i
Composite
Video
with
Audio
or
S-Video
with Audio(Recommended)
(Figure
6)
1.
Connect
a video or an S-Video
cable from
VIDEO OUT on the VCR back panel to VIDEO or
S-VIDEO,
INPUT-1 or INPUT-2 on the TV back
panel.
=
Connect
a set of audio cables from AUDIO OUT
on the VCR back panel to AUDIO INPUT-1 or
INPUT-2 on the TV back panel, matching
the
input used in step 1.
The red cable connects to the R (right) channel
The white cable connects to the L (left) channel
If your VCR is mono (non-stereo),
connect
only
the white (left) cable.
You may connect
to the S-WDEO
or VIDEO
terminam but not to both.
Figure 6. Connecting
the VCR Audio/Video.
Advertisement
