Changes In Utility Mode - Yamaha A3000 Upgrade Manual

Version 2

Hide thumbs Also See for A3000:

Table of Contents

Changes in UTILITY MODE

UTILITY - COMMAND Key - CREATE_OSC [Create Oscillators]

This is a new command. The command can be accessed from the UTILITY mode's MAS-

TER function.

This command automatically generates the following seven "oscillator" samples: sine

wave, saw up, triangle, square, pulse 1, pulse 2, and pulse 3. To execute the command,

push Knob 1.

Note that the command will not create any samples for which matching sample names

already exist.

UTILITY - PANEL PLAY - KnobSet

Parameter assignments for Knobs 3 to 5 have been rearranged: Knob 3 now sets the Device,

Knob 4 sets the controller enable (Ctrl), and Knob 5 sets the transmit channel (T-ch).

• On Version 1, the Device indication showed only the controller number. On Version 2,

• The T-Ch (transmit channel) parameter at Knob 5 can now be set to AUDITION. If

UTILITY - SEQUENCE - SeqSel

Knob 5 now offers three operations: >NEW (create a new sequence; same as on Version

1), >SAVE (save the currently selected sequence), and >DELETE.(delete the currently

selected sequence). Turn the knob to select the operation, then push to execute.

it shows both the controller number and the corresponding device (if any). If you have

set up a knob to act as controller, then the knob name and transmit channel will both

appear next to the controller number (for example, 073/K4( 5) would indicate that

Knob 4 is set to operate as Controller 073 transmitting over Transmit Channel 5).

you set the value to AUDITION, the knob will act as a controller during audition

replay.

[Select Sequence]

Chapter 2

Changes in UTILITY MODE

292

296

Upgrade Reference

Table of Contents

Show Quick Links

Table of Contents