Changes in EDIT MODE
EDIT - COMMAND Key - REVERT
EDIT - COMMAND Key - NORM
EDIT - COMMAND Key - RESMPL - TmStrch [Resampling - Time Stretch]
EDIT - COMMAND Key - REVERS
EDIT - COMMAND Key - LOOPXFD
Chapter 2
Upgrade Reference
28
Changes in EDIT MODE
This page now also shows the name of the selected sample or sample bank.
This page now also shows the name of the sample selected for normalization.
On Version 1, the length was always indicated by address units. On Version 2, you can
also display the length in beats or time units by setting the EndType parameter (in the
EDIT | TRIM/LOOP Config page) to beats or time, respectively.
Unlike Version 1, Version 2 will now retain the loop-start and loop-end addresses after
resampling.
This page now also shows the name of the sample selected for reversal.
• The Area parameter was moved from Knob 3 to Knob 4.
• Knob 3 is now used to select the crossfade curve. For information about curve set-
tings, see the Owner's Manual, page 156.
[Reverse]
[Loop Crossfade]
149
150
151
157
158