Electrolux EWM09312 Service Manual page 10
Hide thumbs
Also See for EWM09312:
- Service manual (70 pages) ,
- Service manual (124 pages) ,
- Service manual (61 pages)
Table of Contents
Advertisement
- Door safety interlock
- Wash solenoid, if the water in
the tub is not enough to cover
8
the heating element
-
Motor (55 rpm clockwise,
55 rpm anti-clockwise,
250 rpm pulse)
- Door safety interlock
- Drain pump
9
- Motor up to 650 rpm then at
maximum spin speed (**)
10
-------
11
- Reading/Deleting the last alarm
- The LEDs, groups of symbols
in the LCD screen and the
backlight of the display are
12
turned on in sequence,
÷
- Press a sensor to turn on the
14
group of icons in the LCD
screen or the corresponding
LED and the buzzer sounds
at the same time.
(*) In most cases, this time is sufficient to check the heating. However, the time can be increased by repeating the phase without draining
the water: pass for a moment to a different phase of the diagnostic cycle and then back to the heating control phase (if the temperature
°
is higher than 80
C, heating does not take place).
(**) The check at the maximum speed occurs without control of the AGS (anti-unbalancing system) and no garments must be inside the
appliance.
2012 SOE/DT-mdm FCPD-dp
Guide to diagnostics of EWM09312 electronic controls
-------
Door closed
Water level above
the heating element
Door closed
Water level lower than
anti-boiling level for
spinning.
-------
-----
Always active
10/69
Check for leaks
from the tub.
Drum speed
in rpm/10
Drain,
calibration of
analogue
pressure switch
Drum speed
and spin.
in rpm/10
-------
-------
----
User interface
functioning
599 75 18-74 Rev.00
Advertisement
Table of Contents
