NEC UNIVERGE SV9100 Manual page 149
Voice over ip
Hide thumbs
Also See for UNIVERGE SV9100:
- Features and specifications (1403 pages) ,
- Programming manual (954 pages) ,
- Manual (766 pages)
Table of Contents
Advertisement
trunk side.
The Networking feature allows the following DISA Class of Service Options.
Trunk Route Access
Operator access
External Paging
The following are not available.
Trunk Group Access
Common Abbreviated dialling
Internal Paging
Specified trunk access
Forced trunk disconnect
Call Forward setting
Break In
Operation
To place a DISA call into the system:
1. Dial the telephone number that rings the DISA trunk.
2. Wait for the DISA trunk to automatically answer with a unique dial tone.
3. Dial the optional 6-digit DISA password.
4. Wait for a second unique dial tone (if password was required).
5. Dial an extension number.
OR
Dial 9 for Trunk Group Routing or ARS.
OR
Dial Alternate Trunk Route Access Code (if enabled).
OR
Dial 805 + a trunk number (1-200) for an outside call.
OR
Dial 0 for the operator.
OR
Dial 803 + an External Paging Zone number (1-8 or 0 for All Call).
If the received digits are analysed as a networked extension number, the call is routed to the appropriate
system within the network.
Hold
This feature is available with no changes in programming or operation.
The MOH tone is sourced at the local system where the caller is hearing the hold tone. For example a user
at System A places a call to system B and puts the call on hold, the MOH source at system B will be heard
by the held user.
Whilst the caller is on hold the network speech path will be reserved, waiting for the call to be taken off
hold.
Direct Station Selection (DSS)
An extension user can have a DSS key to a networked extension. The DSS console keys can display the
status lamp indication of an extension in a networked system.
The key will show the status for idle, busy, DND set and Call Forward Immediate set.
Lamp status may not be updated immediately. Status will be updated in the time interval specified in
system programming, this setting should be consistent at all connected sites.
The status for ACD extensions or Virtual extensions will not be sent via AspireNet. It is still possible to have
a DSS key for an ACD or Virtual extension but it will not show any BLF information, the key can only be used
to call the extension.
The basic status for a Hotel extension is sent via AspireNet e.g. idle, busy, DND set, Call forward set. The
Hotel room status is not sent e.g. check in/out, room status etc.
Part 2: VoIP Manual
149
Advertisement
Table of Contents
Troubleshooting
