NEC UNIVERGE SV9100 Manual page 101
Voice over ip
Hide thumbs
Also See for UNIVERGE SV9100:
- Features and specifications (1403 pages) ,
- Programming manual (954 pages) ,
- Manual (766 pages)
Table of Contents
Advertisement
Upgrade using the SIP MLT Menu
Before following the upgrade procedure, the firmware files must be loaded onto a TFTP/FTP server.
There are three firmware files depending on the type of handset being upgraded: -
itlisipe.tgz
(for use with ITL-2E/6E handsets)
itlisipv.tgz
(for use with ITL-8/12/24/32D handsets)
itlisips.tgz
(for use with ITL-320C handsets)
itzisipvc.tgz
(for use with ITZ-12CG handsets)
itzisipvg.tgz
(for use with ITZ-8LDG,ITZ-12D,ITZ-12DG,ITZ-24D)
Each type of handset will request the correct file name by default.
This procedure must be performed on each handset that requires upgrading.
1.
Press Menu, then 0 (Config) to enter the terminal program mode.
2.
At the Login screen, enter the user name (default = ADMIN) and password (default = 6633222)
and press the OK Softkey.
3.
Press 3 for Maintenance Setting.
4.
Press 1 for Download Menu.
5.
Press 2 for Download Address and enter the IP address of the TFTP/FTP server
6.
Press the OK softkey.
7.
Press 3 for Protocol and choose either TFTP or FTP depending on what type of server you have
available.
8.
Press the OK softkey.
9.
If using an FTP server press 4 for FTP Settings then enter the FTP User ID/Password/Folder and
press the OK softkey after each entry.
10. Press the Exit softkey to get back to the Download Menu.
11. Press 1 for Download Files.
12. Press 3 for Boot & Program.
13. Leave the default file name as it is.
14. Press the Exec softkey.
15. The screen will flash 'Downloading...' whilst the file is downloaded from the TFTP/FTP server.
16. When the download is complete the screen will show 'Saving...' with a progress indicator.
17. When the save is complete the screen will show 'Download Complete! Press the Exit softkey to
Reset.'
18. Press the Exit softkey to reset the terminal.
19. The upgrade procedure is complete.
Automatic Firmware Upgrade
The following procedure should only be performed using Handset Programming or Web Pro
It is possible for the handset to check whether its firmware requires upgrading when it registers to the
SV9100.
It does this by checking its firmware against the version set in system programming.
A TFTP/FTP server is required for this operation, see the information about TFTP/FTP server and firmware
file names in the above method.
1.
PRG84-07-01. Set to 0 to use TFTP or 1 to use FTP. If using FTP you must set the FTP Login
Name in PRG84-07-03 and the FTP Password in PRG84-07-04.
2.
PRG84-07-02. Enter the TFTP/FTP server IP address.
3.
PRG84-28-02. Enter the firmware filename for each terminal type (see above). If using FTP you
must enter the FTP directory in PRG84-28-01.
4.
PRG90-42-01. Enter the firmware version that the handset should compare with. This is the
version that the handsets will be upgraded to (e.g. 03.00.00.00).
5.
PRG90-42-02. Enter the hardware version of each type of handset (see below for hardware
Part 2: VoIP Manual
101
Advertisement
Table of Contents
Troubleshooting
