Sony DTC-670 Operating Instructions Manual page 29
Digital audio tape deck
Hide thumbs
Also See for DTC-670:
- Operating instructions manual (42 pages) ,
- Service manual (79 pages)
Advertisement
Display Window
Each time you press COUNTER MODE, the counter
changes as follows.
a
Linear counter
Om
iis
(tape running time)
Absolute time
4
PGM TIME
=
Elapsed time of the
M
if s __ selection
4
(MADE: |
G
4
REMAINING
ee
eT
ining
time
romanian
emaining time
to
the
tH UUmMULis
end ofthe whole tape
(not to the end of the
recorded portion)*
Notes
@
At the beginning of the tape, " 77" may appear and
immediately go off at the PGM NO. indicator position
depending on some types of pre-recorded tapes.
("33 "" stands for "beginning".)
e@
Toreset the counter to OM OOS, press RESET.
*
When playing back a pre-recorded tape (software),
remaining time to the end of the recorded portion
appears.
To check the sampling frequencies recorded on the
tape — Frequency Map
This operation can be performed only with the remote
commander.
Press the 4 button on the numeric buttons while keeping
the COUNTER MODE button pressed.
Bars on the level meter light to signify the sampling
frequencies with which the material was recorded. (No bars
light until 16 seconds (32 in the long-play mode) after
playback starts.)
32 kHz
Upper bar
44.1 kHz
Both upper and lower bars
48 kHz
Lower bar
"TOP", "MID" and "END" indicate the beginning, middle
and end of each tape respectively.
Example:
ae
I
ee
ee
I
OD
a
ae a ee Caco
TOP !
at
MID:
'
END
32 KHz 44.1 kHz
48 kHz
32 kHz
Blank
Elapsed time of the selection does not appear when...
@
The selection is played back from the middle.
@
The tape is being fast-forwarded or rewound.
@
The cassette compartment
is opened or closed by the
4SOPEN/CLOSE button.
Adjusting the headphones volume
Use the PHONE LEVEL control.
When the tape is played back to its end
The tape will be rewound to the beginning and stop
automatically.
Remaining time does not appear in the following cases
e
Immediately after the deck is set in the playback mode.
The remaining time will appear about 16 seconds (in the
standard-play mode) later.
e@
When playback is started from a blank section
(page
15), the remaining time may not appear. Press the <<
or kd button.
Accuracy of the indicator for the remaining time
According to the kind of tape, the indicated time may differ
slightly from the actual remaining time.
If tape noise exists, or sound quality has deteriorated
The head may be contaminated. Clean the head, using a
cleaning cassette (See page 35).
29
Advertisement
