Advertisement
Available languages
Available languages
of your power tool (B). Before removing the
drill bit, press the button 3 again and pull
the guide 2 all the way outward.
Before removing the drill bit, press the button
3 again and pull the guide 2 all the way out-
ward.
Adjusting the Guide Length
(Fig. 4, 5)
To ensure that dust is extracted cleanly and the
depth stop is set correctly, the guide 2 must be
adjusted so that the tip of the drill bit is flush
at the front with the dust cap 1 (Fig. 5).
1. Press and hold (A) the button 3 and move
(B) the guide 2 until the tip of the drill bit
is flush with the "crosshair" of the dust cap
7 (Fig. 4).
2. Release the button 3.
Note: To store the dust extraction attachment,
press the button 3 and pull the guide 2 all
the way outward. This relieves strain on the
guide's spring, which increases the lifetime of
the spring.
Fig. 5
1
Adjusting the Drilling Depth
(Fig. 6)
The button 1 for depth stop adjustment can be
used to set the required drilling depth X.
Press and hold the button 1 and slide it along
the guide 2 so that the distance X shown in
the illustration matches your required drilling
depth.
When the desired distance X is reached, re-
lease the button 1.
160992A7EN GDE18V-12 20230323.Indd 6
Operating instructions
Fig. 4
1
Fig. 6
(1)
-6-
(3)
(2)
(1)
B
1
x
(2)
A
3/23/23 1:50PM
Advertisement
