Table of Contents
Advertisement
Ground the
Instrument
Do Not Exceed
Voltage Ratings
Prevent Shorted
Connections
Safety Summary
The following safety precautions must be observed during
all phases of operation of this instrument. Failure to
comply with these precautions or with specific warnings
elsewhere in this manual violates safety standards of
design, manufacture, and intended use of the instrument.
Hewlett-Packard assumes no liability for the customer's
failure to comply with these requirements.
To avoid potentially hazardous electrical shock, establish,a
safety ground before connecting user's circuits. Connect
the output cable from the Power Pack to the Digital I/O,
and then connect the line cord from the Power Pack to the
ac line. Detailed instructions are in the HP PC Instruments
System Owner's Manual.
Excessive input voltage and current will damage this
instrument. Do not exceed ±10 V maximum, per input bit.
To prevent shorted connections when assembling your
input and output connectors, do not strip wires back more
than 0,15 in. (4 mm). Only use AWG 20 (0.5 mm2) wire
gauge. Only use the form and type of connector originally
supplied with the equipment.
Advertisement
Table of Contents
