Table of Contents
Advertisement
Installation
1.
Start by connecting the keyboard cable to the system unit.
2.
Connect the monitor cable to the display adapter. Figure shows
a computer with the NDC display adapter for the Nokia
monochrome monitor. If you have a color monitor, the system
unit is equipped with the VGA card. Both NDC and VGA are
preinstalled at the factory.
3.
Connect the power cord of the monitor to the socket on the
system unit. In order to prevent radio interference problems,
the monitor must be powered via the system unit only.
4.
If you have for example a mouse, connect it to the serial port of
the system unit.
5.
The parallel port can be used e.g. for connecting a parallel
printer.
6.
Plug the power cord to the system unit. Then plug the other end
of the cord into a grounded AC outlet. See the back panel of
the system unit for power requirements. Always connect this
power cord last!
Warning: It is very important that you connect the system unit to an
earthed power outlet. Otherwise the chassis, accessible parts and
connector covers will receive a potential equivalent to half the mains
voltage. This potential is caused by charged capacitors. It is entirely
harmless but it can give an umpleasant shock. It can also damage
interface circuits when external options are being connected or
disconnected.
Now, go to the next section, Running the Setup Program.
2-5
Advertisement
Chapters
Table of Contents
