Table of Contents
Advertisement
FusionModule2000 Smart Modular Data Center
Maintenance Guide
Procedure
Step 1 Put on an ESD wrist strap (or ESD gloves) and insert the ground terminal into the ESD jack in
the cabinet.
Step 2 Remove the faulty hard drive.
1.
2.
3.
4.
Figure 6-15 Removing a hard drive
Step 3 Install a new hard drive.
1.
2.
3.
4.
Issue 05 (2020-03-25)
Press the button on the hard drive panel to open the ejector lever.
Pull out the hard drive for about 3 cm, wait for 30 seconds at least until the hard drive
stops rotating, and pull it out.
Use a screwdriver to loosen the screws from the hard drive.
Remove the hard drive.
Install a new hard drive.
Secure the hard drive to the front panel using a screwdriver.
Push the hard drive into the subrack along the guide rails until it cannot move forwards.
Close the ejector lever and push the hard drive in position.
Copyright © Huawei Technologies Co., Ltd.
6 Parts Replacement
67
Advertisement
Table of Contents
