Table of Contents
Advertisement
A
2
B
1
TIP
Check the track for wear and damage at the same time.
Adjusting
1.
Stop the engine and remove the engine switch key.
2.
Loosen the wheel nut on both sides.
1. Wheel nut
1
3.
Loosen the locknut, and adjust the track slack by
turning the adjusting nut.
1. Locknut
2. Adjusting nut
Direction A
Direction B
TIP
There is one adjusting nut in the center.
4.
Tighten the locknut and wheel nuts to the specified
torques.
Tightening torque:
Locknut:
31 N·m (3.1 kgf·m)
Wheel nut:
66 N·m (6.6 kgf·m)
Replacing the sprocket pin
If an excessive load is applied to the driving system, for
example, when the Snowblower is stuck in a rut, the
sprocket pin will be cut to protect the driving system.
If the sprocket pin is broken, replace it immediately.
WARNING
Position the Snowblower on a level surface.
Periodic maintenance
Slack
Increase
Decrease
5-18
Advertisement
Table of Contents
