Table of Contents
Advertisement
Periodic maintenance
1
2
1
2
5-13
2.
Check the clearance between the auger end and
the road surface.
1. Skid
2. Auger end
2
3. Road surface
4. Clearance
4
3
Factory set
(Standard position)
Concrete and asphalt roads
Pebble and gravel roads
3.
Lift the auger housing, using the auger housing
height control lever.
1. Auger housing height control lever
2. Auger housing
1
4.
Loosen the nuts of the skid.
1. Skid
2. Nut
5.
Adjust the skid height by moving the skid vertically,
and then tighten the nuts of the skid.
6.
Contact the skid to the road surface, using the
auger housing height control lever.
7.
Check the clearance between the auger end and
the road surface.
NOTICE
If the clearance between the road surface and the
auger end is too small, auger wear may increase
and the road surface could be damaged.
Clearance between the au-
ger end and the road surface
5 mm
Decrease
Increase
Advertisement
Table of Contents
