Table of Contents
Advertisement
LED Display Settings
The LEDs have three operating modes that can be selected in the system management software:
Normal mode: default after power on. Refer to
n
Off mode: the LED is off
n
Blink mode: the LED blinks green
n
Pressing the reset button for less than 10 seconds during normal operation will toggle the LED mode
between "normal" (default after power on) and "off" mode.
Pressing the reset button for longer than 10 seconds may cause the access point to reset and return to the factory
default state.
LCD Panel
The LCD panel is located on the front panel of the access point that displays the access point's bootup and
system status information.
The LCD button is located on the right side of the LCD panel and used to operate the LCD panel:
When booted up, the LCD will display the home page, which is Aruba logo by default, but it is
n
configurable by the system management software. Short pressing the LCD button will scroll through the
pages on the LCD screen. The LCD display will return to the home page after 10 seconds of inactivity.
Long pressing the LCD button will adjust the LCD's backlight brightness.
n
Table 2: LCD Panel Displays
Acess Point State
During access point boot (system status
LED blinking green)
Access point is up and running (system status
LED solid green)
Access point is in error condition or thermal
shutdown mode (system status LED solid red)
Rev 03 | August 2023
Table
1.
LCD Displays
Display bootup status information, such as "AP powering
up...", "Connecting to network" and etc.
Display logo (home page) and system status information.
Short pressing the LCD button on the right of the LCD screen
will scroll through pages.
Display relevant information about the error condition.
|
3
Advertisement
Table of Contents
