Table of Contents
Advertisement
Figure 11 Installing Cellular Module onto Access Point
Software
For instructions on choosing operating modes and initial software configuration, refer to the
Quick Start
Guide.
Aruba access points are classified as radio transmission devices, and are subject to government regulations of the
host country. The network administrator(s) is/are responsible for ensuring that configuration and operation of this
equipment is in compliance with their country's regulations. For a complete list of approved channels in your
country, refer to the Aruba Downloadable Regulatory Table at
https://www.arubanetworks.com/techdocs/DRT/content/home.htm.
Verifying Post-Installation Connectivity
The integrated LEDs on the access point can be used to verify that the access point is receiving power and
initializing successfully. See
Electrical and Environmental Specifications
Electrical
Ethernet:
n
E0 port: 100/1000Base-T auto-sensing MDI/MDX wired RJ45 network connectivity port
l
E1 port: 100/1000/2500Base-T auto-sensing MDI/MDX wired RJ45 network connectivity port
l
E2 port: 100/1000Base-T auto-sensing MDI/MDX wired RJ45 network connectivity port
l
E3 port: 100/1000Base-T auto-sensing MDI/MDX wired RJ45 network connectivity port
l
E4 port: 100/1000Base-T auto-sensing MDI/MDX wired RJ45 network connectivity port, supporting
l
PoE-PSE to a 802.3af-compliant device.
Power
n
48V DC power interface, support powering through AC-to-DC power adapter
l
Maximum power consumption: Refer to datasheet
l
10
|
Table
1,
Table 1
and
Table
3.
AP Software
Rev 03|August 2023
Advertisement
Table of Contents
