Table of Contents
Advertisement
Available languages
Available languages
• Do not use the two-stroke oil for water-cooled
outboard engines. The two-stroke oil is sometimes
referred to as outboard oil.
Gasoline,liter
5
10
15
20
To make the fuel mixture
• Always use a clean fuel container when you mix
the fuel.
• Do not make more than 30 days quantity of fuel
mixture.
• If the machine is not used for some time the fuel
tank should be emptied and cleaned.
1. Add half of the gasoline quantity.
2. Add the full quantity of oil.
3. Shake the fuel mixture to mix the contents.
4. Add the remaining gasoline quantity.
5. Shake the fuel mixture to mix the contents.
6. Fill the fuel tank.
To add fuel
WARNING: Do not smoke or put hot
objects near fuel. Before you add fuel,
stop the engine and let it cool for minutes.
WARNING: When you add fuel, open the
fuel tank cap slowly so that any excess
pressure is released gently.
WARNING: After you add fuel, tighten the
fuel tank cap carefully. Move the machine
away from the refuelling area and the
power before you start the engine.
• Always use a fuel container with an anti-spill valve.
• Clean the area around the fuel cap. Contamination
in the tank can cause operating problems.
• Ensure that the fuel is well mixed by shaking the
container before filling the tank.
To start and stop
To examine before start
• Check the drills. Never use drills that are blunt,
cracked or damaged.
• Check that the machine is in perfect working order.
Check that all nuts and screws are tight.
• Check that the drill attachment always stops when
the engine is idling.
8
Oil,liter
2%(50:1)
0.1
0.2
0.3
0.4
• Only use the machine for the purpose it was
intended for.
• Make sure that the handle and safety features are
in good working order. Never use a machine that
lacks a part or has been modified outside its
specifications.
• All covers must be correctly fitted and undamaged
before you start the machine.
To start a cold engine
WARNING: Install the drill bit before
starting the product.
WARNING: Move the product away from
the refuelling area and the power. Put it on
a flat surface. Make sure that no objects
touch the drill attachment.
WARNING: Make sure that no unauthorised
persons are in the work area. Or it can
cause a risk of dangerous injury. The
safety distance is 5 m.
1. Put the stop switch to the start position.
2. Put the brake trigger lever in the brake position
before starting the machine.
3. Press the air purge ten times.
4. Move choke control to the choke position.
5. Hold the product to the ground. Pull out the cord
slowly with your right hand until you feel some
resistance. Pull the cord quickly and with force.
Keep doing it until you hear the engine start.
Note: Do not twist the starter rope around your hand.
CAUTION: Do not pull all the starter rope
out. Hold the starter rope handle when it is
fully extended. Failure to obey these
instructions can cause damage to the engine.
6. Set the choke control to the run position, then pull
the start rope until the engine starts.
7. Pull the throttle trigger lightly and run at low speed
for 60 seconds.
WARNING: Do not touch the cover. It
can burn your skin and cause electrical
shock if the spark plug cap is damaged.
Do not use a product with damaged
spark plug cap.
Advertisement
Chapters
Table of Contents
